MetalworkingFun Forum › Machining › Welding & Casting v
Vice rebuild

Thread Modes
Vice rebuild
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
f350ca (08-11-2015)
#13
08-11-2015, 01:56 AM
I believe reinforced concrete is the most widely used material in damn building Greg Big Grin

I'd get the vice nice and warm first. I stuck mine in the bbq and closed the lid. I left it there whist I brazed it and then close the lid once finished so it could cool slowly.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Vice rebuild - by f350ca - 08-08-2015, 06:52 PM
RE: Vice rebuild - by Mayhem - 08-08-2015, 07:16 PM
RE: Vice rebuild - by f350ca - 08-08-2015, 08:23 PM
RE: Vice rebuild - by Pete O - 08-09-2015, 05:30 AM
RE: Vice rebuild - by ieezitin - 08-09-2015, 06:36 AM
RE: Vice rebuild - by f350ca - 08-09-2015, 08:34 AM
RE: Vice rebuild - by ieezitin - 08-09-2015, 09:10 AM
RE: Vice rebuild - by f350ca - 08-09-2015, 07:54 PM
RE: Vice rebuild - by Mayhem - 08-10-2015, 06:03 AM
RE: Vice rebuild - by Dr Stan - 08-10-2015, 07:50 AM
RE: Vice rebuild - by stevec - 08-10-2015, 06:04 PM
RE: Vice rebuild - by f350ca - 08-10-2015, 07:40 PM
RE: Vice rebuild - by Mayhem - 08-11-2015, 01:56 AM
RE: Vice rebuild - by ieezitin - 08-11-2015, 04:29 PM
RE: Vice rebuild - by mattmcp - 08-18-2015, 08:44 PM



Users browsing this thread: 1 Guest(s)