08-09-2015, 10:54 AM
If you can cut a test bar on your lathe with less then .0005 error in 4 inches you can make a square the ends should be dipped in so that it only sits on the rim at the outer edge.
In one of the home workshop series of books it tells how to make one, Harold Hall Lathework a complete course #34 is the one.
In one of the home workshop series of books it tells how to make one, Harold Hall Lathework a complete course #34 is the one.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!