08-09-2015, 06:54 AM
Your better off to make your own out of pipe or tube. Making them on the lathe is easy... make sets of 4 all equal length ranging from 1-1/2'' to 4'' in 1/2'' increments.
The beauty of these is you can use them as set ups on the mill or shaper and even on the face plate of a lathe, they fix to the table / plate like tool maker buttons. They take up less room than angle plates, they also provide great usefulness on the surface plate.
Anthony.
The beauty of these is you can use them as set ups on the mill or shaper and even on the face plate of a lathe, they fix to the table / plate like tool maker buttons. They take up less room than angle plates, they also provide great usefulness on the surface plate.
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.