MetalworkingFun Forum › Machining › Metrology v
Cylindrical Square

Thread Modes
Cylindrical Square
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#3
08-08-2015, 10:56 PM
Greg,

I did a ton of Goggling "wrist pins" and most of them are hollow and a lot of the larger ones are already ground on the ends. I just need to find one at a good price on ebay.

Ed
Reply
Thanks given by:


Messages In This Thread
Cylindrical Square - by EdK - 08-08-2015, 05:49 PM
RE: Cylindrical Square - by f350ca - 08-08-2015, 06:48 PM
RE: Cylindrical Square - by EdK - 08-08-2015, 10:56 PM
RE: Cylindrical Square - by Mayhem - 08-09-2015, 04:41 AM
RE: Cylindrical Square - by EdK - 08-09-2015, 09:49 AM
RE: Cylindrical Square - by ieezitin - 08-09-2015, 06:54 AM
RE: Cylindrical Square - by EdK - 08-09-2015, 08:58 AM
RE: Cylindrical Square - by dallen - 08-09-2015, 10:54 AM
RE: Cylindrical Square - by EdK - 08-14-2015, 02:44 PM
RE: Cylindrical Square - by PixMan - 08-16-2015, 07:59 AM
RE: Cylindrical Square - by Mayhem - 10-30-2015, 01:39 AM
RE: Cylindrical Square - by Highpower - 10-30-2015, 10:50 AM
RE: Cylindrical Square - by Mayhem - 10-30-2015, 07:13 PM
RE: Cylindrical Square - by wawoodman - 11-04-2015, 10:43 AM
RE: Cylindrical Square - by EdK - 11-04-2015, 05:04 PM
RE: Cylindrical Square - by wawoodman - 11-05-2015, 09:19 PM



Users browsing this thread: 3 Guest(s)