05-31-2012, 09:18 PM
i bet that there is a third world shop with 1/10 the tooling available than i have that could manage this repair and could use the tool ten times as productively as i could.
putting the gears back on while it would have been a challenge to me i think i could have pulled that off but it would have been a waste of time since i couldnt harden them.
i dont know what but im putting something direct drive onto that spent gear.
putting the gears back on while it would have been a challenge to me i think i could have pulled that off but it would have been a waste of time since i couldnt harden them.
i dont know what but im putting something direct drive onto that spent gear.
mikecwik, proud to be a member of MetalworkingFun Forum since Apr 2012.