07-28-2015, 08:49 AM
Hi Wong - nice to see you back here!
You could try something like THIS. The last post on page 2 is what Al is thinking (if I understood his post).
First, you make the aluminium soft jaws and then bore them on your lathe (as shown in the link above), so they hold the wheels. Then you remove the chuck from your lathe and set that up on your mill, so the chuck holds the wheels.
You could try something like THIS. The last post on page 2 is what Al is thinking (if I understood his post).
First, you make the aluminium soft jaws and then bore them on your lathe (as shown in the link above), so they hold the wheels. Then you remove the chuck from your lathe and set that up on your mill, so the chuck holds the wheels.
Hunting American dentists since 2015.