07-23-2015, 08:09 PM
(07-23-2015, 08:01 PM)DaveH Wrote: I have thought about these plastic "bits" - not a lot though.
I thought it would be better if I didn't use a raised 'bump' but just screwed it in place with some recessed screws. Heck of a lot easier than trying to make it with 'bumps' on.
DaveH
That was exactly my thought; the plastic will be low-friction anyway, bumps will just wear out quickly.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.