07-21-2015, 05:32 PM
Had a little 4" cheap rotary table kicking about for a while that someone dropped in for conversion to stepper drive.
As a had a bit of loose time I started to do this.
![[Image: 4in%20rotary%20table1.jpg]](http://www.stevenson-engineers.co.uk/files/4in%20rotary%20table1.jpg)
Not the best table in the world but this is all the guy has. Motor is a type 17 as it only needs 5 gnat power to run this.
So bit of bodging, hammering, bashing and a tad of common sense and we get this.
![[Image: 4in%20rotary%20table2.jpg]](http://www.stevenson-engineers.co.uk/files/4in%20rotary%20table2.jpg)
Works OK and has a little backlash but nowhere near as much as I expected. See what the guy says tomorrow.
As a had a bit of loose time I started to do this.
Not the best table in the world but this is all the guy has. Motor is a type 17 as it only needs 5 gnat power to run this.
So bit of bodging, hammering, bashing and a tad of common sense and we get this.
Works OK and has a little backlash but nowhere near as much as I expected. See what the guy says tomorrow.
John S., Nottingham, England.