MetalworkingFun Forum › Machining › General Metalworking Discussion v
What should be the allowance for press fitting?

Thread Modes
What should be the allowance for press fitting?
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#17
05-30-2012, 06:47 AM
Tony,
I used that method once making some phosphor bronze bearings 6mm dia ball bearing for the holes, I have never tried it on steel, do you think it will work on steel?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
What should be the allowance for press fitting? - by ukazak - 05-29-2012, 12:56 AM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 12:37 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 03:09 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 04:03 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 04:48 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 05:05 PM
RE: What should be the allowance for press fitting? - by DaveH - 05-30-2012, 06:47 AM
RE: What should be the allowance for press fitting? - by ukazak - 05-30-2012, 11:19 AM
RE: What should be the allowance for press fitting? - by ukazak - 05-31-2012, 12:46 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-30-2012, 04:50 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-31-2012, 12:43 PM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 03:11 AM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 02:17 PM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 03:57 PM



Users browsing this thread: 9 Guest(s)