MetalworkingFun Forum › Machining › General Metalworking Discussion v
Rotary table storage box

Thread Modes
Rotary table storage box
Dave J Offline
Sophmore
***
Posts: 183
Threads: 22
Joined: Feb 2012
Location: Australia
#7
02-22-2012, 09:34 AM
Thanks guys
Mayhem, they are only cut with the jigsaw. There are 3 layers of different thickness ply all glued together. Sort of like making gaskets and gluing them together. I did end up routering the bottom board to get a bit extra depth and a finger hole, but I could have just used 4 layers instead.

Dave
Reply
Thanks given by:


Messages In This Thread
Rotary table storage box - by Dave J - 02-17-2012, 01:57 AM
RE: Rotary table storage box - by DaveH - 02-17-2012, 03:24 AM
RE: Rotary table storage box - by Dave J - 02-17-2012, 08:16 AM
RE: Rotary table storage box - by Highpower - 02-17-2012, 08:43 AM
RE: Rotary table storage box - by EdK - 02-17-2012, 07:23 PM
RE: Rotary table storage box - by Mayhem - 02-22-2012, 07:19 AM
RE: Rotary table storage box - by Dave J - 02-22-2012, 09:34 AM
RE: Rotary table storage box - by Rickabilly - 07-13-2016, 08:14 PM
RE: Rotary table storage box - by Rickabilly - 07-13-2016, 08:15 PM
RE: Rotary table storage box - by Dr Stan - 07-13-2016, 09:30 PM
RE: Rotary table storage box - by pepi - 07-13-2016, 09:42 PM



Users browsing this thread: 2 Guest(s)