MetalworkingFun Forum › Machining › General Metalworking Discussion v
looking to purchase some tooling

Thread Modes
looking to purchase some tooling
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#12
07-15-2015, 04:05 PM
Here's my Fray #7 All angle on which I mounted a 4" Dayton copy of a Kurt.  I bought the 4" as I thought it was very appropriate for the size of the machine.  It came with an old 6" vice that was just way too large.


[Image: DSCN0924.jpg]
Reply
Thanks given by:


Messages In This Thread
looking to purchase some tooling - by Kennyv - 07-14-2015, 09:48 AM
RE: looking to purchase some tooling - by JScott - 07-14-2015, 10:13 AM
RE: looking to purchase some tooling - by Shawn - 07-14-2015, 11:06 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 11:23 AM
RE: looking to purchase some tooling - by EdK - 07-14-2015, 03:55 PM
RE: looking to purchase some tooling - by Vinny - 07-14-2015, 03:57 PM
RE: looking to purchase some tooling - by Kennyv - 07-14-2015, 11:09 PM
RE: looking to purchase some tooling - by Vinny - 07-15-2015, 04:01 PM
RE: looking to purchase some tooling - by Dr Stan - 07-15-2015, 04:05 PM
RE: looking to purchase some tooling - by Dr Stan - 07-17-2015, 10:05 AM
RE: looking to purchase some tooling - by Kennyv - 07-17-2015, 01:05 PM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 07:22 AM
RE: looking to purchase some tooling - by PixMan - 07-17-2015, 10:35 AM



Users browsing this thread: 2 Guest(s)