2 lathes please take a quick look
#12
(07-14-2015, 05:43 PM)Roadracer_Al Wrote: ...  Is there a "show us pictures of your lathe" thread I should add it to?

There sure is: http://www.metalworkingfun.com/thread-15.html

Ed
Reply
Thanks given by:


Messages In This Thread
2 lathes please take a quick look - by Kennyv - 07-12-2015, 01:55 PM
RE: 2 lathes please take a quick look - by Vinny - 07-12-2015, 02:25 PM
RE: 2 lathes please take a quick look - by Kennyv - 07-12-2015, 02:45 PM
RE: 2 lathes please take a quick look - by PixMan - 07-12-2015, 08:47 PM
RE: 2 lathes please take a quick look - by Kennyv - 07-13-2015, 12:42 PM
RE: 2 lathes please take a quick look - by f350ca - 07-13-2015, 04:41 PM
RE: 2 lathes please take a quick look - by EdK - 07-14-2015, 05:48 PM



Users browsing this thread: 1 Guest(s)