looking to purchase some tooling

[JScott]

Kv, my HF mill has a 10x28 in table and I bought a 4" vise for it.  This vise fits perfectly on my machine and a 5" or 6" would be too much of a good thing.  If I get to a point where a work piece is too big for my vise I'll just clamp or fixture it right to the table.  Just my 2¢ and YMMV.

This vise is a Kurt lookalike that my wife purchased on eBay from jtsmachinery for my birthday last year.

http://www.ebay.com/itm/4-MILLING-MACHIN...43d9fc45d2

And as an FYI I took the swivel base off and put it in long term storage.  Hope this is helpful.