07-09-2015, 08:58 PM
Stumbled on these in the local classified by accident:
Four matched, ground and hardened block that are approximately 2" x 1" x 5/8" and three machinist jacks that extend from 1-1/4" to 2-1/8". Apparently the blocks were machined specifically to fit the ways on a horizontal mill but I figure that they will come in handy.
He was asking $20 for the lot, so I contacted him and told him to consider them sold. He lives about an hour away from me but virtually next door to a colleague at work. Her husband grabbed them for me and apparently the guy selling them is/was a tool and die maker.
Four matched, ground and hardened block that are approximately 2" x 1" x 5/8" and three machinist jacks that extend from 1-1/4" to 2-1/8". Apparently the blocks were machined specifically to fit the ways on a horizontal mill but I figure that they will come in handy.
He was asking $20 for the lot, so I contacted him and told him to consider them sold. He lives about an hour away from me but virtually next door to a colleague at work. Her husband grabbed them for me and apparently the guy selling them is/was a tool and die maker.
Hunting American dentists since 2015.