05-29-2012, 10:07 AM
Thanks Dave.
There's actually far more work into than may appear from those photos. On the bottom side of the plate the area around the two mounting holes (clearance of M8 x 1.25 SHCS) are raised bosses to sit inside the counterbores of the handlebar clamps. It was the first time my dad's 10" vert/horiz Yuasa rotary table had been used, and it's almost 10 years old!
Mayhem, I do glance at the revs, but only when I'm really winding it up. Technically I'm still on break-in miles, so I want to stay under certain RPM ranges.
There's actually far more work into than may appear from those photos. On the bottom side of the plate the area around the two mounting holes (clearance of M8 x 1.25 SHCS) are raised bosses to sit inside the counterbores of the handlebar clamps. It was the first time my dad's 10" vert/horiz Yuasa rotary table had been used, and it's almost 10 years old!
Mayhem, I do glance at the revs, but only when I'm really winding it up. Technically I'm still on break-in miles, so I want to stay under certain RPM ranges.