MetalworkingFun Forum › Machinery › Milling Machines v
[PROJECT] Power Drawbar For PM-935T Mill

Thread Modes
Project Power Drawbar For PM-935T Mill
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#4
07-06-2015, 04:29 PM
I opened up the wrench this evening to inspect the guts of it. I was expecting worse. The gasket is even labeled as being oil resistant and made in England. The machining of the parts is not nearly as bad as I was expecting.

Ed

   
Reply
Thanks given by:


Messages In This Thread
Power Drawbar For PM-935T Mill - by EdK - 07-05-2015, 04:42 PM
RE: Power Drawbar For PM-935T Mill - by Mayhem - 07-06-2015, 05:41 AM
RE: Power Drawbar For PM-935T Mill - by EdK - 07-06-2015, 04:29 PM
RE: Power Drawbar For PM-935T Mill - by f350ca - 07-06-2015, 07:25 PM
RE: Power Drawbar For PM-935T Mill - by rleete - 07-07-2015, 07:19 AM
RE: Power Drawbar For PM-935T Mill - by EdK - 07-07-2015, 04:05 PM
RE: Power Drawbar For PM-935T Mill - by EdK - 07-11-2015, 10:16 AM
RE: Power Drawbar For PM-935T Mill - by Mayhem - 07-07-2015, 06:25 AM
RE: Power Drawbar For PM-935T Mill - by f350ca - 07-11-2015, 12:38 PM
RE: Power Drawbar For PM-935T Mill - by EdK - 07-11-2015, 01:01 PM



Users browsing this thread: 2 Guest(s)