07-05-2015, 10:52 PM
Nothing to exciting, a friend in Maryland was selling some Trumpf nibbler tooling, I don't have a Trumpf but have a Pullmax or two. So this is how Trumpf makes them for offset / joggling helps stiffen flat sheet.
how they would work in the machine
my setup, small vise on a 8" palmgren rotary table on a old BP
I took light cuts till I got the set up "debugged" tightened up!
still need to weld shanks on to them, trying different depths on the flats surface, the joggle depth is .060
may make another set or two with little more offset depth, but want to try them out 1st. See if there any major fubars!
how they would work in the machine
my setup, small vise on a 8" palmgren rotary table on a old BP
I took light cuts till I got the set up "debugged" tightened up!
still need to weld shanks on to them, trying different depths on the flats surface, the joggle depth is .060
may make another set or two with little more offset depth, but want to try them out 1st. See if there any major fubars!
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.