05-29-2012, 12:56 AM
What should be the allowance for press fitting?
Hi,
Fun shoppinn time to everybody,
Is there a rule of thumb or something like that which will determine the press fitting?
I mean, to a given drilled hole size, what should be the parts size could press fit? Lets say the drilled hole size is 4mm, and part to fit 4.05, 4.10 or 4.20, what should be for proper size?
What is too much, what is not enough
any tips, please..? 
Unal
Hi,
Fun shoppinn time to everybody,
Is there a rule of thumb or something like that which will determine the press fitting?
I mean, to a given drilled hole size, what should be the parts size could press fit? Lets say the drilled hole size is 4mm, and part to fit 4.05, 4.10 or 4.20, what should be for proper size?
What is too much, what is not enough
any tips, please..? Unal