|
Hand Cut Gear Quadrant
|
07-04-2015, 07:40 PM
(07-04-2015, 07:24 PM)EdK Wrote: That's a curious way to retract the guard. I'll have to go look at my sliding miter saw and see how it's done on it. Ed This is the only mitre saw that O have seen with this type of mechanism, most are a slide with a bushing or bearing acting as a cam follower. Walter
starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.
Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hand Cut Gear Quadrant - by starlight_tools - 07-04-2015, 03:56 PM
RE: Hand Cut Gear Quadrant - by DaveH - 07-04-2015, 05:32 PM
RE: Hand Cut Gear Quadrant - by starlight_tools - 07-04-2015, 06:00 PM
RE: Hand Cut Gear Quadrant - by EdK - 07-04-2015, 07:24 PM
RE: Hand Cut Gear Quadrant - by starlight_tools - 07-04-2015, 07:40 PM
RE: Hand Cut Gear Quadrant - by awemawson - 07-05-2015, 03:13 AM
RE: Hand Cut Gear Quadrant - by PixMan - 07-05-2015, 08:46 AM
RE: Hand Cut Gear Quadrant - by starlight_tools - 07-05-2015, 07:20 PM
RE: Hand Cut Gear Quadrant - by woody90 - 07-08-2015, 08:59 AM
|
