05-28-2012, 04:19 PM
Arvid,
If you're talking about import clamping sets than you should be able to mill the T-nuts without too much problems. I had to mill some T-nuts for my angle table and they milled reasonably well without too much problem so I think if you have a decent end mill you should be able to mill the T-nuts without a problem.
Ed
If you're talking about import clamping sets than you should be able to mill the T-nuts without too much problems. I had to mill some T-nuts for my angle table and they milled reasonably well without too much problem so I think if you have a decent end mill you should be able to mill the T-nuts without a problem.
Ed