MetalworkingFun Forum › Machining › General Metalworking Discussion v
Slitting saw problem

Thread Modes
Slitting saw problem
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#8
06-30-2015, 07:18 AM
(06-30-2015, 06:15 AM)PixMan Wrote: I'd be at half to one third that speed with HSS.
Thumbsup  I agree.

I use 2" dia saws at a speed of 125rpm. 125rpm is the slowest speed on my mill so there is no point in using a larger dia saw. The high surface speed will just blunt the HSS saw very quickly.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Slitting saw problem - by Roadracer_Al - 06-28-2015, 01:59 PM
RE: Slitting saw problem - by DaveH - 06-28-2015, 04:52 PM
RE: Slitting saw problem - by PixMan - 06-28-2015, 07:11 PM
RE: Slitting saw problem - by TomG - 06-28-2015, 08:42 PM
RE: Slitting saw problem - by Mayhem - 06-29-2015, 06:06 AM
RE: Slitting saw problem - by Roadracer_Al - 06-30-2015, 12:07 AM
RE: Slitting saw problem - by PixMan - 06-30-2015, 06:15 AM
RE: Slitting saw problem - by DaveH - 06-30-2015, 07:18 AM
RE: Slitting saw problem - by Roadracer_Al - 07-01-2015, 12:27 PM



Users browsing this thread: 3 Guest(s)