Slitting saw problem
#7
300 rom with a 3" cutter is 235 surface feet per minute, or 72 meters per minute. While that bronze is easy cutting, it can be fairly abrasive. Tool wear would be my bet.

I'd be at half to one third that speed with HSS.
Reply
Thanks given by:


Messages In This Thread
Slitting saw problem - by Roadracer_Al - 06-28-2015, 01:59 PM
RE: Slitting saw problem - by DaveH - 06-28-2015, 04:52 PM
RE: Slitting saw problem - by PixMan - 06-28-2015, 07:11 PM
RE: Slitting saw problem - by TomG - 06-28-2015, 08:42 PM
RE: Slitting saw problem - by Mayhem - 06-29-2015, 06:06 AM
RE: Slitting saw problem - by Roadracer_Al - 06-30-2015, 12:07 AM
RE: Slitting saw problem - by PixMan - 06-30-2015, 06:15 AM
RE: Slitting saw problem - by DaveH - 06-30-2015, 07:18 AM
RE: Slitting saw problem - by Roadracer_Al - 07-01-2015, 12:27 PM



Users browsing this thread: 4 Guest(s)