06-29-2015, 09:47 PM
Well, just in case I left any of you sitting breathlessly on the edge of your seat, my tachometer (same model) that I ordered from a US company came in today. It works.
I did use it on the HF X2 mini mill. I was badly under-guesstimating the RPMs. Usually by at least 100. So it is a worthwhile acquisition for me.
Charles
I did use it on the HF X2 mini mill. I was badly under-guesstimating the RPMs. Usually by at least 100. So it is a worthwhile acquisition for me.
Charles
Charles Spencer, proud to be a member of MetalworkingFun Forum since Aug 2014.