Slitting saw problem
#4
A wandering saw is almost always due to a dull cutter, so either the ones you chose were already dull or your rpm was too high for the material. For the record, if I have a long cut to make, I'll plunge the saw into the side of the part rather than let it feed the entire length of cut. That way if the is a wandering issue, it won't get out of hand and scrap the part.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Slitting saw problem - by Roadracer_Al - 06-28-2015, 01:59 PM
RE: Slitting saw problem - by DaveH - 06-28-2015, 04:52 PM
RE: Slitting saw problem - by PixMan - 06-28-2015, 07:11 PM
RE: Slitting saw problem - by TomG - 06-28-2015, 08:42 PM
RE: Slitting saw problem - by Mayhem - 06-29-2015, 06:06 AM
RE: Slitting saw problem - by Roadracer_Al - 06-30-2015, 12:07 AM
RE: Slitting saw problem - by PixMan - 06-30-2015, 06:15 AM
RE: Slitting saw problem - by DaveH - 06-30-2015, 07:18 AM
RE: Slitting saw problem - by Roadracer_Al - 07-01-2015, 12:27 PM



Users browsing this thread: 1 Guest(s)