Slitting saw problem
#2
300rpm? a lot will depend on the slitting saw dia. and the pitch of the teeth. Normally they need to be run quite slowly.
ie a 5" slitting saw about 50rpm
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:


Messages In This Thread
Slitting saw problem - by Roadracer_Al - 06-28-2015, 01:59 PM
RE: Slitting saw problem - by DaveH - 06-28-2015, 04:52 PM
RE: Slitting saw problem - by PixMan - 06-28-2015, 07:11 PM
RE: Slitting saw problem - by TomG - 06-28-2015, 08:42 PM
RE: Slitting saw problem - by Mayhem - 06-29-2015, 06:06 AM
RE: Slitting saw problem - by Roadracer_Al - 06-30-2015, 12:07 AM
RE: Slitting saw problem - by PixMan - 06-30-2015, 06:15 AM
RE: Slitting saw problem - by DaveH - 06-30-2015, 07:18 AM
RE: Slitting saw problem - by Roadracer_Al - 07-01-2015, 12:27 PM



Users browsing this thread: 2 Guest(s)