|
air engine
|
06-27-2015, 04:51 PM
hi I sed I had bin hard at it did sum more to the air engine made up the connector from the crank to the piston then made the valve and valve nut to all that have joined the forum may not no that I don't have a mill so a lot of the work is dun by hand right pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
air engine - by krv3000 - 02-22-2014, 03:42 PM
RE: air engine - by doubleboost - 02-22-2014, 03:54 PM
RE: air engine - by krv3000 - 02-22-2014, 04:24 PM
RE: air engine - by Micktoon - 02-22-2014, 06:16 PM
RE: air engine - by Mayhem - 02-22-2014, 08:21 PM
RE: air engine - by krv3000 - 03-02-2014, 05:37 PM
RE: air engine - by Micktoon - 03-03-2014, 05:33 PM
RE: air engine - by DaveH - 03-05-2014, 11:20 AM
RE: air engine - by krv3000 - 05-03-2015, 11:53 AM
RE: air engine - by krv3000 - 05-03-2015, 12:05 PM
RE: air engine - by krv3000 - 06-27-2015, 04:51 PM
RE: air engine - by Mayhem - 06-27-2015, 08:31 PM
RE: air engine - by krv3000 - 07-12-2015, 05:22 PM
RE: air engine - by Mayhem - 07-12-2015, 05:47 PM
RE: air engine - by Micktoon - 07-12-2015, 06:03 PM
RE: air engine - by EdK - 07-12-2015, 06:11 PM
RE: air engine - by krv3000 - 08-07-2015, 04:46 PM
|
