|
3mm groove in inox steel
|
|
06-27-2015, 09:42 AM
Since you probably don't have a wire EDM at your disposal, another option would be to band saw it. Just weld (or braze) the blade together with it through the hole and saw the inner slot, then the outer slot, or vice versa. Make sure you lay it out first so you have good lines to follow.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
3mm groove in inox steel - by rado7rado - 06-26-2015, 11:52 AM
RE: 3mm groove in inox steel - by PixMan - 06-26-2015, 12:40 PM
RE: 3mm groove in inox steel - by rado7rado - 06-26-2015, 02:57 PM
RE: 3mm groove in inox steel - by DaveH - 06-26-2015, 01:04 PM
RE: 3mm groove in inox steel - by lilyies - 06-26-2015, 10:24 PM
RE: 3mm groove in inox steel - by Roadracer_Al - 06-26-2015, 10:57 PM
RE: 3mm groove in inox steel - by TomG - 06-27-2015, 09:42 AM
|
