|
Help Welding Disc To Threaded Rod
|
06-26-2015, 03:21 PM
(06-26-2015, 10:45 AM)zmotorsports Wrote: Snip the wire at an angle prior to starting a new puddle to give the current a chance to start the process quicker and will better penetration. Mike,  I don't understand the "snip the wire at an angle" part at all.  Could you explain what an angled point on a .025 or .030 wire would accomplish ? Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Welding Disc To Threaded Rod - by EdK - 06-26-2015, 08:51 AM
RE: Welding Disc To Threaded Rod - by Mayhem - 06-26-2015, 09:01 AM
RE: Welding Disc To Threaded Rod - by EdK - 06-26-2015, 09:06 AM
RE: Welding Disc To Threaded Rod - by f350ca - 06-26-2015, 09:35 AM
RE: Welding Disc To Threaded Rod - by zmotorsports - 06-26-2015, 10:45 AM
RE: Welding Disc To Threaded Rod - by stevec - 06-26-2015, 03:21 PM
RE: Welding Disc To Threaded Rod - by zmotorsports - 06-26-2015, 09:15 PM
RE: Welding Disc To Threaded Rod - by Roadracer_Al - 06-26-2015, 11:34 AM
RE: Welding Disc To Threaded Rod - by EdK - 06-26-2015, 12:18 PM
RE: Welding Disc To Threaded Rod - by zmotorsports - 06-26-2015, 01:39 PM
RE: Welding Disc To Threaded Rod - by stevec - 06-27-2015, 06:25 AM
RE: Welding Disc To Threaded Rod - by TomG - 06-27-2015, 09:28 AM
RE: Welding Disc To Threaded Rod - by ieezitin - 06-27-2015, 03:31 PM
RE: Welding Disc To Threaded Rod - by EdK - 06-27-2015, 05:35 PM
|
