Going back and checking levels I noticed that the bench is actually level in the center but is almost a half bubble off at the right side of the mill where the red arrow is. Maybe that's where I should put the support. I can move those drawers over.
![[Image: bench-sink_zpsu8i0p6mr.jpg]](http://i974.photobucket.com/albums/ae229/MyOwnStuff/bench-sink_zpsu8i0p6mr.jpg)
![[Image: bench-sink_zpsu8i0p6mr.jpg]](http://s974.photobucket.com/user/MyOwnStuff/media/bench-sink_zpsu8i0p6mr.jpg.html)
|
Bench Support?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Bench Support? - by Thumb - 06-24-2015, 11:28 PM
RE: Bench Support? - by stevec - 06-25-2015, 05:16 AM
RE: Bench Support? - by PixMan - 06-25-2015, 06:40 AM
RE: Bench Support? - by Thumb - 06-25-2015, 07:45 AM
RE: Bench Support? - by Charles Spencer - 06-25-2015, 08:15 AM
RE: Bench Support? - by Thumb - 06-25-2015, 08:44 AM
RE: Bench Support? - by Thumb - 06-25-2015, 09:11 AM
RE: Bench Support? - by dallen - 06-25-2015, 10:38 AM
|
Users browsing this thread: 1 Guest(s)