MetalworkingFun Forum › Machinery › Milling Machines v
Bench Support?

Thread Modes
Bench Support?
Thumb Offline
Sophmore
***
Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or
#4
06-25-2015, 07:45 AM
I don't think it was but then I never looked at it as close as I did after setting the mill on it. As far as putting extra legs on it, that wouldn't be a bad idea either and might be just the ticket.

Thanks for your input guys.
Reply
Thanks given by:


Messages In This Thread
Bench Support? - by Thumb - 06-24-2015, 11:28 PM
RE: Bench Support? - by stevec - 06-25-2015, 05:16 AM
RE: Bench Support? - by PixMan - 06-25-2015, 06:40 AM
RE: Bench Support? - by Thumb - 06-25-2015, 07:45 AM
RE: Bench Support? - by Charles Spencer - 06-25-2015, 08:15 AM
RE: Bench Support? - by Thumb - 06-25-2015, 08:44 AM
RE: Bench Support? - by Thumb - 06-25-2015, 09:11 AM
RE: Bench Support? - by dallen - 06-25-2015, 10:38 AM



Users browsing this thread: 2 Guest(s)