Bench Support?
#2
I don't think the "front to back" brace would do a lick of good to rectify the "side to middle bow" without at least a "5th leg" to the floor.
A bit late to ask now, but was the "bow" or sag of the bench there before the mill was installed?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Bench Support? - by Thumb - 06-24-2015, 11:28 PM
RE: Bench Support? - by stevec - 06-25-2015, 05:16 AM
RE: Bench Support? - by PixMan - 06-25-2015, 06:40 AM
RE: Bench Support? - by Thumb - 06-25-2015, 07:45 AM
RE: Bench Support? - by Charles Spencer - 06-25-2015, 08:15 AM
RE: Bench Support? - by Thumb - 06-25-2015, 08:44 AM
RE: Bench Support? - by Thumb - 06-25-2015, 09:11 AM
RE: Bench Support? - by dallen - 06-25-2015, 10:38 AM



Users browsing this thread: 2 Guest(s)