06-24-2015, 10:22 PM
Another big part.
This bull gear apparently was off a hay bailer. Had to bore it out to 2.890 to fit the shaft. Forgot to get a photo of it on the mill. This will give about 8.5 : 1 reduction from the engine to the paddles.
Quality control stepped in for a size comparison.
This bull gear apparently was off a hay bailer. Had to bore it out to 2.890 to fit the shaft. Forgot to get a photo of it on the mill. This will give about 8.5 : 1 reduction from the engine to the paddles.
Quality control stepped in for a size comparison.
Free advice is worth exactly what you payed for it.
Greg
Greg