MetalworkingFun Forum › Machining › General Metalworking Discussion v
DC motor, power supply question

Thread Modes
DC motor, power supply question
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#7
06-24-2015, 04:05 PM
The answer was so obvious I was blind to it. I'm going to use two 12VDC batteries hooked up in series and then just separate them to charge them up with a car battery charger. Doh
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
DC motor, power supply question - by Shawn - 06-19-2015, 01:44 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 01:57 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 02:11 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 03:12 PM
RE: DC motor, power supply question - by Vinny - 06-19-2015, 05:20 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 05:52 PM
RE: DC motor, power supply question - by Shawn - 06-24-2015, 04:05 PM



Users browsing this thread: 1 Guest(s)