DC motor, power supply question
#4
good, a shaper will leave a mirror finish if set up right,

was just wondering hadn't seen you around for a while.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
DC motor, power supply question - by Shawn - 06-19-2015, 01:44 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 01:57 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 02:11 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 03:12 PM
RE: DC motor, power supply question - by Vinny - 06-19-2015, 05:20 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 05:52 PM
RE: DC motor, power supply question - by Shawn - 06-24-2015, 04:05 PM



Users browsing this thread: 4 Guest(s)