DC motor, power supply question
#3
Hi Dallen, I thought I posted a video of the shaper running with the new brass block in place? It's running great and the brass you sent is holding up really well. I just discovered the other day that the weird witness marks the tool was leaving on the return stroke was related to the crappy machine vise I was using. I put the heavy duty vice (I was hoping to send you till I found out the shipping was going to be near $400) on the Shaper and its cutting smooth and very quiet. 
Jawdrop
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
DC motor, power supply question - by Shawn - 06-19-2015, 01:44 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 01:57 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 02:11 PM
RE: DC motor, power supply question - by dallen - 06-19-2015, 03:12 PM
RE: DC motor, power supply question - by Vinny - 06-19-2015, 05:20 PM
RE: DC motor, power supply question - by Shawn - 06-19-2015, 05:52 PM
RE: DC motor, power supply question - by Shawn - 06-24-2015, 04:05 PM



Users browsing this thread: 2 Guest(s)