MetalworkingFun Forum › Machining › General Metalworking Discussion v
PEEK plastic material

Thread Modes
PEEK plastic material
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 1 user Likes PixMan's post:
wrustle (06-18-2015)
#4
06-18-2015, 06:17 AM
Best of luck Russ! I know you can try machining it like Delrin but it can be even harder to hold onto it. It loves to pop right out of a vise if you push too hard. At the cost of that material it behooves you to take it easy.
Reply
Thanks given by:


Messages In This Thread
PEEK plastic material - by wrustle - 06-17-2015, 04:21 PM
RE: PEEK plastic material - by PixMan - 06-17-2015, 04:36 PM
RE: PEEK plastic material - by wrustle - 06-17-2015, 06:29 PM
RE: PEEK plastic material - by PixMan - 06-18-2015, 06:17 AM
RE: PEEK plastic material - by Mayhem - 06-18-2015, 07:16 AM
RE: PEEK plastic material - by wrustle - 06-18-2015, 06:53 PM
RE: PEEK plastic material - by Pete O - 06-18-2015, 09:41 PM
RE: PEEK plastic material - by Vinny - 06-18-2015, 09:58 PM
RE: PEEK plastic material - by wrustle - 06-20-2015, 08:09 AM
RE: PEEK plastic material - by PixMan - 06-20-2015, 02:41 PM
RE: PEEK plastic material - by EdK - 06-20-2015, 06:18 PM



Users browsing this thread: 2 Guest(s)