MetalworkingFun Forum › Machining › General Metalworking Discussion v
PEEK plastic material

Thread Modes
PEEK plastic material
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#2
06-17-2015, 04:36 PM
Yeah, that stuff is priced like GOLD, ain't it?

Have you machined it yet? I've not done much milling, but turned and drilled a fair bit of it. While it cuts more like a soft steel in some ways, it can wear out tools like a ore-heat treated steel would.
Reply
Thanks given by:


Messages In This Thread
PEEK plastic material - by wrustle - 06-17-2015, 04:21 PM
RE: PEEK plastic material - by PixMan - 06-17-2015, 04:36 PM
RE: PEEK plastic material - by wrustle - 06-17-2015, 06:29 PM
RE: PEEK plastic material - by PixMan - 06-18-2015, 06:17 AM
RE: PEEK plastic material - by Mayhem - 06-18-2015, 07:16 AM
RE: PEEK plastic material - by wrustle - 06-18-2015, 06:53 PM
RE: PEEK plastic material - by Pete O - 06-18-2015, 09:41 PM
RE: PEEK plastic material - by Vinny - 06-18-2015, 09:58 PM
RE: PEEK plastic material - by wrustle - 06-20-2015, 08:09 AM
RE: PEEK plastic material - by PixMan - 06-20-2015, 02:41 PM
RE: PEEK plastic material - by EdK - 06-20-2015, 06:18 PM



Users browsing this thread: 4 Guest(s)