MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Question on Albrecht Keyless Chuck

Thread Modes
Question on Albrecht Keyless Chuck
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 2 users Like PixMan's post:
EdK (06-15-2015), DaveH (06-15-2015)
#8
06-15-2015, 04:09 PM
If you're using it on a "mill/drill", I would strongly advise against ever using it for the "mill" part of that machine. Side loading is a bad idea for a good Albrecht!
Reply
Thanks given by:


Messages In This Thread
Question on Albrecht Keyless Chuck - by Swede56 - 06-10-2015, 11:37 AM
RE: Question on Albrecht Keyless Chuck - by EdK - 06-15-2015, 04:08 PM
RE: Question on Albrecht Keyless Chuck - by PixMan - 06-15-2015, 04:09 PM



Users browsing this thread: 5 Guest(s)