06-14-2015, 09:50 AM
Interesting way to go about it Mayhem . I am going to mod my draw bar to accommodate an 11/16 extended nut . Prob going to wait till Monday ,weld it on shaft. However I was wondering does anyone know if I used silver solder ( Braze) and did it that way at home do you think it would hold up as well?
I have my hands full already to get garage in order. Was hoping some one read about my Idea of the tear bench wrack for bench machines. Last night did make some grounds with 2 options , still not sure which route to take . Build a 5 tier shelf (rack bench). ALL MAHINES NEED TO BE ACCESABLE Or I can take existing grind bench work out functional layout of 5 bench machines (2 shelves 2 machines on each) Mount belt sander on side . And build two shelves over existing bench using the shelving material listed above. Still have a rolling 3 shelf wrack available for stock. Thanks for any ideas .
Hope that made sense ?
Please don't make me take pics before job take me half the day. Promise ill post the there . Thanks again Kenny V
I have my hands full already to get garage in order. Was hoping some one read about my Idea of the tear bench wrack for bench machines. Last night did make some grounds with 2 options , still not sure which route to take . Build a 5 tier shelf (rack bench). ALL MAHINES NEED TO BE ACCESABLE Or I can take existing grind bench work out functional layout of 5 bench machines (2 shelves 2 machines on each) Mount belt sander on side . And build two shelves over existing bench using the shelving material listed above. Still have a rolling 3 shelf wrack available for stock. Thanks for any ideas .
Hope that made sense ?
Please don't make me take pics before job take me half the day. Promise ill post the there . Thanks again Kenny V