Let's See Your Mill

[zmotorsports]

(06-12-2015, 10:23 AM)EdK Wrote: Thanks Mike and good point on the table moving up and down. I didn't think of that since I've never owned a knee mill before. The spindle height will have to do then. I'm about 5'3" on most days so the height is a concern for me.

Thanks,
Ed

Ed, I ran home at lunch and grabbed those measurements for you.

From the ground to the bottom of the spindle mine measures 55". This is sitting on a my base which is 8.5" tall.

At that height my table is in the 40"-45" for much of my smaller work.

I hope that helps you out on size/height.

Mike.