Let's See Your Mill

[EdK]

(06-12-2015, 10:47 AM)zmotorsports Wrote:

(06-12-2015, 10:23 AM)EdK Wrote: Thanks Mike and good point on the table moving up and down. I didn't think of that since I've never owned a knee mill before. The spindle height will have to do then. I'm about 5'3" on most days so the height is a concern for me.

Thanks,
Ed

I will measure it for you Ed, but with your height (or lack thereof ) you may be fine with it standing directly on the floor.

Mike.

I'm hoping that's the case. My welding sucks.

Ed