MetalworkingFun Forum › Machinery › Lathes v
[HELP] How much oil?

Thread Modes
Help How much oil?
Scruffy Offline
Freshman
**
Posts: 24
Threads: 4
Joined: Feb 2014
Location: Ohio
#18
06-10-2015, 09:08 PM (This post was last modified: 06-10-2015, 09:08 PM by Scruffy.)
The only reason the shop is clean is because everything is jammed to one end. Had to do that to get this lathe moved in.
The shaper is a 16 in cinn back geared , similar to dal lens.


Attached Files Thumbnail(s)
   
Scruffy, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:


Messages In This Thread
How much oil? - by Scruffy - 05-28-2015, 04:41 PM
RE: How much oil? - by PixMan - 05-28-2015, 09:22 PM
RE: How much oil? - by Dr Stan - 05-28-2015, 10:17 PM
RE: How much oil? - by Mayhem - 05-29-2015, 04:13 AM
RE: How much oil? - by Scruffy - 05-30-2015, 07:12 AM
RE: How much oil? - by Scruffy - 05-30-2015, 07:14 AM
RE: How much oil? - by Scruffy - 05-30-2015, 07:15 AM
RE: How much oil? - by Mayhem - 05-30-2015, 08:09 AM
RE: How much oil? - by PixMan - 05-30-2015, 01:20 PM
RE: How much oil? - by Vinny - 05-30-2015, 02:46 PM
RE: How much oil? - by Mayhem - 05-30-2015, 08:35 PM
RE: How much oil? - by f350ca - 05-30-2015, 08:38 PM
RE: How much oil? - by Good Mann - 05-30-2015, 04:27 PM
RE: How much oil? - by EdK - 05-30-2015, 04:38 PM
RE: How much oil? - by Dr Stan - 05-30-2015, 05:02 PM
RE: How much oil? - by dallen - 05-30-2015, 06:17 PM
RE: How much oil? - by Good Mann - 05-30-2015, 08:47 PM
RE: How much oil? - by Scruffy - 06-10-2015, 09:08 PM
RE: How much oil? - by Vinny - 06-10-2015, 09:31 PM
RE: How much oil? - by stevec - 06-11-2015, 06:15 AM
RE: How much oil? - by Vinny - 06-11-2015, 11:11 AM
RE: How much oil? - by PixMan - 06-11-2015, 06:16 AM
RE: How much oil? - by PixMan - 06-11-2015, 08:35 PM



Users browsing this thread: 2 Guest(s)