MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tramming the head on a mill

Thread Modes
Tramming the head on a mill
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
PixMan (06-08-2015)
#2
06-08-2015, 06:33 PM
Hey Darren,

It's best to tram with the table centered because they do sag a bit when cranked to one side, especially with weight on the table. It doesn't take much to affect the pattern on a milling cutter.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: Mayhem


Messages In This Thread
Tramming the head on a mill - by Mayhem - 06-08-2015, 09:48 AM
RE: Tramming the head on a mill - by TomG - 06-08-2015, 06:33 PM
RE: Tramming the head on a mill - by PixMan - 06-08-2015, 07:49 PM
RE: Tramming the head on a mill - by Mayhem - 06-09-2015, 08:01 AM
RE: Tramming the head on a mill - by stevec - 06-09-2015, 06:38 PM
RE: Tramming the head on a mill - by zmotorsports - 06-11-2015, 02:29 PM



Users browsing this thread: 1 Guest(s)