MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machining Stainless Steel

Thread Modes
Machining Stainless Steel
ScrapMetal Offline
Junior
****
Posts: 275
Threads: 12
Joined: Mar 2012
Location: Nebraska, USA
#12
05-26-2012, 04:28 PM
I made these "discs" out of 303 using my old SB lathe and HSS cutters - dry. Just used a slow speed, "light" cuts and sharp tooling.

[Image: sose001.jpg]

FYI - Outer diameter is about 1".

-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:


Messages In This Thread
Machining Stainless Steel - by EdK - 05-25-2012, 04:59 PM
RE: Machining Stainless Steel - by doubleboost - 05-25-2012, 05:19 PM
RE: Machining Stainless Steel - by DaveH - 05-25-2012, 05:20 PM
RE: Machining Stainless Steel - by EdK - 05-25-2012, 05:24 PM
RE: Machining Stainless Steel - by doubleboost - 05-25-2012, 05:59 PM
RE: Machining Stainless Steel - by EdK - 05-25-2012, 06:00 PM
RE: Machining Stainless Steel - by ukazak - 05-25-2012, 07:48 PM
RE: Machining Stainless Steel - by DaveH - 05-25-2012, 08:18 PM
RE: Machining Stainless Steel - by aametalmaster - 05-25-2012, 08:51 PM
RE: Machining Stainless Steel - by DaveH - 05-26-2012, 10:42 AM
RE: Machining Stainless Steel - by ukazak - 05-26-2012, 04:21 AM
RE: Machining Stainless Steel - by ScrapMetal - 05-26-2012, 04:28 PM
RE: Machining Stainless Steel - by EdK - 05-26-2012, 04:37 PM
RE: Machining Stainless Steel - by DaveH - 05-26-2012, 04:57 PM
RE: Machining Stainless Steel - by ScrapMetal - 05-27-2012, 01:11 AM
RE: Machining Stainless Steel - by RobWilson - 05-27-2012, 02:17 AM
RE: Machining Stainless Steel - by EdK - 05-27-2012, 08:31 AM
RE: Machining Stainless Steel - by Mayhem - 05-28-2012, 06:49 AM
RE: Machining Stainless Steel - by Highpower - 05-28-2012, 10:11 AM
RE: Machining Stainless Steel - by krv3000 - 05-28-2012, 06:59 AM
RE: Machining Stainless Steel - by DaveH - 05-28-2012, 01:38 PM
RE: Machining Stainless Steel - by EdK - 05-28-2012, 04:24 PM
RE: Machining Stainless Steel - by Wongster - 05-31-2012, 11:00 AM
RE: Machining Stainless Steel - by doubleboost - 05-31-2012, 04:47 PM
RE: Machining Stainless Steel - by November X-ray - 05-31-2012, 06:02 PM



Users browsing this thread: 6 Guest(s)