MetalworkingFun Forum › Machining › General Metalworking Discussion v
A job for Ken ( Walter tooling)

Thread Modes
A job for Ken ( Walter tooling)
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#10
06-07-2015, 06:11 AM
No use to me either, but thank you for the kind offer.

You really don't need a lot of HP to run one and it's fun to set up a lathe and plow a big hole. Here's a couple examples of the tools:

http://www.ebay.co.uk/itm/Vollbohrer-Wen...2596ffff9c
http://www.ebay.co.uk/itm/USED-WAUKESHA-...4d3075a53f
Reply
Thanks given by:


Messages In This Thread
A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 07:25 AM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 03:38 PM
RE: A job for Ken ( Walter tooling) - by DaveH - 06-06-2015, 03:56 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 04:07 PM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 04:59 PM
RE: A job for Ken ( Walter tooling) - by Vinny - 06-06-2015, 05:20 PM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-06-2015, 07:05 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 03:21 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 05:36 AM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-07-2015, 06:11 AM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 06:23 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 06:27 AM



Users browsing this thread: 5 Guest(s)