MetalworkingFun Forum › Machining › General Metalworking Discussion v
A job for Ken ( Walter tooling)

Thread Modes
A job for Ken ( Walter tooling)
RobWilson
Unregistered
 
#8
06-07-2015, 03:21 AM
Hi Ken ,,,,,,,,,,,,, cheers for the info ,big help . 

What you have told me is they are  of no f*^cking use to me  Slaphead    Rotfl Rotfl Rotfl   ,  must of had them sitting in the back of the draw for years . 



Are they of any use to you Ken ?  free , zip ,nowt yours if you want them  Smile  .


Rob 
Reply
Thanks given by:


Messages In This Thread
A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 07:25 AM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 03:38 PM
RE: A job for Ken ( Walter tooling) - by DaveH - 06-06-2015, 03:56 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 04:07 PM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 04:59 PM
RE: A job for Ken ( Walter tooling) - by Vinny - 06-06-2015, 05:20 PM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-06-2015, 07:05 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 03:21 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 05:36 AM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-07-2015, 06:11 AM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 06:23 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 06:27 AM



Users browsing this thread: 3 Guest(s)