06-06-2015, 06:38 PM
Yep, here's the proof. Although I used a straight edge this time, it caused the slight mess in the top cut when the thumb screw hit the clamp holding the straight edge and tilted the cutter in on an angle.
So, I had a couple beers, dragged everything outside, started the hilo and raised the forks to a comfortable work height, found the best place to start and between the straight edge and some freehand the edge would only be in the way for (corners) we have a better cut and my mill table will now be 37" instead of 37.5".
![[Image: new-cut.jpg]](http://metalshop.nobucks.net/pix/new-cut.jpg)
So, I had a couple beers, dragged everything outside, started the hilo and raised the forks to a comfortable work height, found the best place to start and between the straight edge and some freehand the edge would only be in the way for (corners) we have a better cut and my mill table will now be 37" instead of 37.5".
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique