A job for Ken ( Walter tooling)
#2
Hey Rob u weren't callin me out were ya?

Little confused with the post wasn't sure if ya were saying or asking? sorry most folks call me Kenny v
anyways those their inserts don't look that odd .They do look like they will fit a boring bar Pos an Index mill cutter . Measure that there hole see what size screw look at insert charts from Kentamedal, Sanvic , Valinite (sp) . you may come across style/ tool that looks like a fit .Other than that make bor bar to fit em,,, Just an Idea .
Reply
Thanks given by:


Messages In This Thread
A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 07:25 AM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 03:38 PM
RE: A job for Ken ( Walter tooling) - by DaveH - 06-06-2015, 03:56 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-06-2015, 04:07 PM
RE: A job for Ken ( Walter tooling) - by Kennyv - 06-06-2015, 04:59 PM
RE: A job for Ken ( Walter tooling) - by Vinny - 06-06-2015, 05:20 PM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-06-2015, 07:05 PM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 03:21 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 05:36 AM
RE: A job for Ken ( Walter tooling) - by PixMan - 06-07-2015, 06:11 AM
RE: A job for Ken ( Walter tooling) - by RobWilson - 06-07-2015, 06:23 AM
RE: A job for Ken ( Walter tooling) - by Mayhem - 06-07-2015, 06:27 AM



Users browsing this thread: 3 Guest(s)