06-05-2015, 07:25 PM
hey guys so i got one of the alluminum bar about a inch wide and 4 feet wide now i cut it in smaller size and i was in the process of making some 90 degree bends in it for what i need and the second to last bend almost broke off i could just feel that i went a lil to far and you can see a hairline crack in it but it is still togather this piece is being hung on wall and light weight hung from it (not to much weight just a few leather sheath's from a couple knives) i just dont want it to compleatly break do i just need to start over (really dont want to do that) can i strengthen that bend some how to make sure it wont break i was thinking maybe putting a lil "jb weld clear weld" epoxy on and around would than make it stronger? any advice would really be apreciated 