|
Help Rotary table want to make good decision
|
06-05-2015, 11:42 AM
I have an 8 inch vertex and often wish it was bigger, but it depends on what your building. You can always put a smaller part on a bigger table. The smaller table limits you when trying to clamp on the outside if some parts. The dividing plates and handle for my Vertex dividing head fit the Vertex rotary table of that helps.
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rotary table want to make good decision - by Kennyv - 06-05-2015, 09:37 AM
RE: Rotary table want to make good decision - by dallen - 06-05-2015, 10:18 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 10:42 AM
RE: Rotary table want to make good decision - by Kennyv - 06-05-2015, 10:49 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:23 PM
RE: Rotary table want to make good decision - by f350ca - 06-05-2015, 11:42 AM
RE: Rotary table want to make good decision - by EdK - 06-05-2015, 01:25 PM
RE: Rotary table want to make good decision - by Vinny - 06-05-2015, 04:11 PM
RE: Rotary table want to make good decision - by Kennyv - 06-12-2015, 09:07 AM
RE: Rotary table want to make good decision - by zmotorsports - 06-12-2015, 09:29 AM
|
